Firmware Design

K-Technics Provides Firmware Design and programming in C, and C++ languages for a majority of 8, 16, and 32 bit micros. K-Technics has successfully implemented protocols for wireless, serial, and SPI communications. Also, we have interfaced to a variety of integrated circuits, LCD controllers, and electronic components.

K-Technics has experience with the following microcontrollers and microprocessors:

  • Atmel AVR
  • 8051 compatible Architectures
  • Microchip PIC Series
  • ATSAM Series
  • ARM7, ARM9, ARM11
  • ST
  • NXP

And the following micro integrated development environments:

  • Keil uVision
  • AVR Studio with GNU WinAVR
  • Microchip MPLAB
  • MikroElectronica mikroC
  • Arduino IDE
  • Coocox IDE

Hardware Design

K-Technics designs Embedded Hardware based on microprocessors, systems-on-chip (SoC), FPGA, DSP and MCU. We gather initial technical and functional requirements, design schematic diagrams and multilayer printed circuit boards. The Design Considerations include:

  • Signal Integrity considerations
  • Power Integrity considerations
  • High speed routing guide lines
  • Differential Signal and Impedance control routing guide lines.
  • Power planes and PCB Stack design consideration
  • Thermal considerations
  • Environmental safety requirements and RoHS

Schematic Diagrams

At K-Technics, we design revision controlled schematics with highest accuracy levels, and highest readability. This means our schematics symbols, schematic component placement and wiring of the circuit is done in such a way that it increases the readability of the Schematics. And we perform multiple cycles of verification of the design right from block level diagram, part selection, symbol creation, schematic entry and till the complete design of the system.

Designing digital and Mixed Signal schematic diagrams based on modern electronic components. Implementation of high-speed interfaces , integration with wireless data transfer modules (WiFi, ZigBee, Bluetooth, GSM/GPRS) and other hardware interfaces.

Printed Circuit Boards
Designing multilayer printed circuit boards of Class 5 and above, using BGA components, controlling impedance. We develop in accordance with the IPC standards, adhere to design-for-test (DFT) and design-for-manufacture (DFM) requirements, analyze signal integrity (SI), electromagnetic compatibility (EMC) and thermal conditions throughout the entire design cycle.

We additionally give our pcb customers, 3D step models and 3d pictures of the board so that our customers can see the pcb for fitment problems before actually sending the design for manufacturing. Our Customers can import our 3d step model into their CAD tools for integration and validation of the PCB Design with their mechanical design.
K-Technics also possess extensive experience in low power, low cost Electronics design.

 

You’ve got stuck on your design or you have no idea where to start or what best to use? At K-technics, we have a highly dedicated and experienced team to help you right away.

Kindly contact our support and design team through +25412799123.