Arduino Mega Micro controller Development Board ADK

Features:

  • 4 UARTs (hardware serial ports),
  • A 16 MHz crystal oscillator,
  • A USB connection,

KES 4,000.00

Description

FEATURES

  • The Arduino MEGA ADK is a microcontroller board based on the ATmega2560.
  • It has a USB host interface to connect with Android based phones, based on the MAX3421e IC.
  • It has 54 digital input/output pins (of which 15 can be used as PWM outputs),
  • 16 analog inputs,
  • 4 UARTs (hardware serial ports),
  • a 16 MHz crystal oscillator,
  • a USB connection,
  • a power jack,
  • an ICSP header, and
  • a reset button.
POWER

The Arduino MEGA ADK can be powered via the USB connection or with an external power supply. The power source is selected automatically.

External (non-USB) power can come either from an AC-to-DC adapter (wall-wart) or battery.

The adapter can be connected by plugging a 2.1mm center-positive plug into the board’s power jack.

Leads from a battery can be inserted in the Gnd and Vin pin headers of the POWER connector.

 

The power pins are as follows:

  • VIN. The input voltage to the Arduino board when it’s using an external power source (as opposed to 5 volts from the USB connection or other regulated power source). You can supply voltage through this pin, or, if supplying voltage via the power jack, access it through this pin.
  • 5V. This pin outputs a regulated 5V from the regulator on the board. The board can be supplied with power either from the DC power jack (7 – 12V), the USB connector (5V), or the VIN pin of the board (7-12V). Supplying voltage via the 5V or 3.3V pins bypasses the regulator, and can damage your board. We don’t advise it.
  • 3V3. A 3.3 volt supply generated by the on-board regulator. Maximum current draw is 50 mA.
  • GND. Ground pins.
  • IOREF. This pin on the Arduino board provides the voltage reference with which the microcontroller operates. A properly configured shield can read the IOREF pin voltage and select the appropriate power source or enable voltage translators on the outputs for working with the 5V or 3.3V.

 

 

Reviews

There are no reviews yet.

Only logged in customers who have purchased this product may leave a review.