SERVO MOTOR DS04-NFC 360 ° ARDUINO

KES 1,500.00

Description

SERVO MOTOR CONTINUOUS ROTATION SERVOMOTOR 360 ° ARDUINO

Features:

  • Supply voltage: from 4.8Vdc 6Vdc
  • maximum no-load speed: 0.22s / 60 ° to 4.8Vdc
  • Stall torque: 5.5Kg / cm at 4.8Vdc
  • Rotation: continuous
  • Pulse Frequency: 50Hz
  • Pulse Width: 1000us to 2000uS
  • Pulse Width stall: 1500US (calibrated)
  • Temperature range: from 0 ° C to + 55 ° C
  • Length cable connections: 280mm
  • Dimensions: 40mm x 20mm x 43mm, see drawing
  • Weight: 37g

Parameters for setting the speed and direction of rotation:

Unlike an angular positioning control servo motor, a rotation servomotor (also called improperly servo 360 °) equally uses a PWM control signal, but the pulse duration determines the speed and direction of rotation (continuous ) and not the angular positioning in the following manner:

  • Pulse width Pw from 1000us to 1500US, Vcc = 4.8V
    The rotation is counterclockwise typically with a speed that the maximum value of 0.22s / 60 ° (45 revolutions / minute) to Pw = 1000us is reduced, with the increase of Pw, until the stall (stop) to Pw = 1500US.
  • Pulse width Pw from 1500US to 2000uS, Vcc = 4.8V
    The rotation is typically clockwise sense with a speed that stall for Pw = 1500US is increased, with the increase of Pw, up to the maximum value of 0.22s / 60 ° (45 rpm / minute) to Pw = 2000uS

On a side of the actuator body is a hole that allows to act on a trimmer that allows to calibrate the value Pw required for the pulse duration to get the stalemate.

Reviews

There are no reviews yet.

Be the first to review “SERVO MOTOR DS04-NFC 360 ° ARDUINO”

Your email address will not be published. Required fields are marked *