Arduino DRV8825 microstepping bipolar stepper motor driver 8.2V ~ 45V 2.5A

  • 1 x DRV8825 stepper driver
  • 1 x heatsink

KES 300.00



  •  The DRV8825 stepper motor driver carrier is a breakout board for TI’s DRV8825 microstepping bipolar stepper motor driver.
  • The module has a pinout and interface that are nearly identical to those of our A4988 stepper motor driver board, so it can be used as a higher-performance drop-in replacement for those boards in many applications.
  • The DRV8825 features adjustable current limiting, overcurrent and overtemperature protection, and six microstep resolutions (down to 1/32-step).
  • It operates from 8.2 – 45 V and can deliver up to approximately 1.5 A per phase without a heat sink or forced air flow (rated for up to 2.2 A per coil with sufficient additional cooling).
  • Simple step and direction control interface
  •  Six different step resolutions: full-step, half-step, 1/4-step, 1/8-step, 1/16-step, and 1/32-step
  •  Adjustable current control lets you set the maximum current output with a potentiometer, which lets you use voltages above your stepper motor’s rated voltage to achieve higher step rates
  •  45 V maximum supply voltage
  •  Built-in regulator (no external logic voltage supply needed)
  • Can interface directly with 3.3 V and 5 V systems
  • Over-temperature thermal shutdown, over-current shutdown, and under-voltage lockout
  • Short-to-ground and shorted-load protection
  • 4-layer, 2 oz copper PCB for improved heat dissipation
  • Exposed solderable ground pad below the driver IC on the bottom of the PCB
  • Module size, pinout, and interface match those of our A4988 stepper motor driver carriers in most respects (see the bottom of this page for more information)

Relative 4988 Features Benefits:

1. the maximum current of 2.5A.
2. up to 32 segments.
3.4-layer PCB, better heat dissipation.
4. the chip resistance is smaller, lower heat, better heat dissipation.


Drive stepper motors.
It is to build a 3d printer, cnc, engraving machine and other necessary modules.
Supported 3d printer has Prusa Mendel, ultimaker, printbot, makerbot like.
You can refer to the back of the A rduino code, direct drive motor
Package list
  • 1 x DRV8825 stepper driver
  • 1 x heatsink