A3144 Hall Effect Sensor


  • Solid-State Reliability
  • Small Size
  • Resistant to Physical Stress

KES 100.00

Out of stock

SKU: 562 Category:



  • The A3144 is an integrated Hall effect non-latching sensor.
  • Holding a magnet near the sensor will cause the output pin to toggle.
  • This makes for a robust presence sensor. A reed sensor also works nicely, but can be limited by the glass encapsulation and size.
  • A hall effect sensor is much smaller, but can handle less current than a reed switch.
  • The device includes an on-chip Hall voltage generator for magnetic sensing, a comparator that amplifies the Hall voltage, and a Schmitt trigger to provide switching hysteresis for noise rejection, and open-collector output.
  • An internal bandgap regulator is used to provide temperature compensated supply voltage for internal circuits and allows a wide operating supply range.
  • If a magnetic flux density larger than threshold Bop, the output is turned on (low). The output state is held until a magnetic flux density reversal falls below Brp causing the output to be turned off (high)  


  • Superior Temp. Stability for Automotive or Industrial Applications
  • 4.5 V to 24 V operation, works with most unregulated supplies
  • Open-Collector 25 mA output, compatible with digital logic
  • Reverse Battery Protection
  • Activate with Small, Commercially Available Permanent Magnets


There are no reviews yet.

Only logged in customers who have purchased this product may leave a review.