Atmel AVR MKII Clone
- Programs both Flash and EEPROM
- Based on AT AVRISP mkII firmware
- Supports Fuses and Lock Bit Programming
PICKIT 3 Programmer/Debugger
USB (Full speed 12 Mbits/s interface to host PC)
MPLAB IDE compatible (free copy included)
Built-in over-voltage/short circuit monitor
Firmware upgradeable from PC/web download
Supports low voltage to 2.0 volts (2.0v to 6.0v range)
Diagnostic LEDs (power, busy, error)
Read/write program and data memory of microcontroller
Erase of program memory space with verification
Freeze-peripherals at breakpoint
Program up to 512K byte flash with the Programmer-to-Go
Pocket AVR Programmer – USBtiny
Works under multiple platforms. Linux, Mac OS X and Windows are tested.
No special controllers or smd components are needed.
Programming speed is up to 5kBytes/sec.
SCK option to support targets with low clock speed (< 1,5MHz). Planned: serial interface to target (e.g. for debugging)
USBASP AVR Programmer-USB TINY
USBasp is a USB in-circuit programmer for Atmel AVR controllers. It simply consists of an ATMega88 or an ATMega8 and a couple of passive components. The programmer uses a firmware-only USB driver, no special USB controller is needed.
USBI SP PROGRAMMER
-Compatible with a wide range of boards, including all Arduino boards
-Compatible with the Arduino IDE on Linux, Windows, and Mac
Showing all 7 results